Installation manual

COLLAR PLATE DISASSEMBLY

Chain Guide Removal

If your chain guide is damaged and needs to be replaced,

locate the two screws that attach the chain guide to the collar

plate and note their position. You will want to reinstall the

chain guide in the same position later. Using a 2.5 mm hex

wrench, remove the screws and chain guide.

Cable Stop Removal

If your cable stop is damaged and needs to be replaced, use a

2 mm hex wrench to remove the screws and cable stop.

Overdrive Pawl Removal

Using a pick, carefully lift and pull back on the overdrive spring

to remove it.

NOTE:

Be careful not to damage the spring upon removal by over

stretching or kinking it. If the spring is damaged upon removal,

replace it with a new one.

Remove the three pawls from their seats.

TECHNICAL SERVICE