Installation manual

COLLAR PLATE ASSEMBLY SERVICE

Parts and tools needed for service:

• Safetyglasses

• Gloves

• 2,2.5,and4mmhexwrenches

• Cleanrags

• Pick

• HammerSchmidtgreasekit*

• Smallgreasebrush(optional)

* You must use the grease supplied in the HammerSchmidt grease kit

unless otherwise speciﬁed. Using any other grease will void your warranty.

R E M O V E T H E C O L L A R P L A T E

ASSEMBLY

Shift the HammerSchmidt into overdrive by pressing the small

shifter paddle. Using a 4 mm hex wrench, loosen the cable

anchor bolt and remove the cable. Remove the housing from

the cable housing stop.

If you have ISCG 03 tabs, remove the collar seal to access the

HammerSchmidt mounting bolts.

Using a 4 mm hex wrench to remove the 3 mounting bolts. Slide

the collar plate off the bike.

TECHNICAL SERVICE