Installation manual

B A S H G U A R D I N S T A L L A T I O N

To replace the bash guard place it over the planet nuts. Using a

5 mm hex wrench, tighten the bash guard bolts. Torque to

4.5 N·m (40 in-lb).

R E A S S E M B L E T H E M E C H A N I S M

ASSEMBLY AND DRIVE SIDE CRANK

ARM

For reassembly of the mechanism assembly and drive side crank

arm follow the instructions as shown under headings “Drive

Mechanism and Crank Arm Installation” in the Installation section

of this manual.

This concludes the Mechanism Assembly and Drive Side Crank

Arm Service for your HammerSchmidt. You did a great job!

TECHNICAL SERVICE