Installation manual

Place the bearing assembly on top of the carrier assembly.

Wiggle them together until the bearing assembly slides slightly

into the carrier assembly. Turn the ring gear counter-clockwise

to ensure the gears mesh properly. Continue to turn the

bearing assembly counter-clockwise until it is fully hand

threaded into the carrier assembly.

Place mechanism assembly on the base of the bearing removal

tool so the tool pins ﬁt into the recesses on the outer race.

Place the tool clamp over the planet posts. Using a 5 mm hex

wrench secure the clamp to the HammerSchmidt with the

planet nuts. Torque to 5.6 N·m (50 in-lb).

Using a 24 mm wrench, tighten the mechanism assembly.

Torque to 25 N·m (217 in-lb). Remember the HammerSchmidt

mechanism assembly is left hand threaded.

TECHNICAL SERVICE