Installation manual

R E A S S E M B L E B E A R I N G A S S E M B L Y

Apply a thin bead of grease in the space between the bearing

and the outer race.

Replace the bearing seal by placing it over the bearing and

pressing it ﬁrmly into the groove on the outer race.

A screwdriver may be required to push the last portion of the

bearing seal into the groove.

Ring Spacer and Damper Assembly

If the ring spacer and damper were removed in disassembly,

they should be reassembled now.

Using a new damper, press the wide portion of the damper into

the back of the groove. To seat the damper properly, work

around the circle pushing both into the groove and slightly

back towards the section already in the groove.

Once the damper is in, apply light pressure to the damper to

smooth the damper and seat it evenly. Verify that there are no

twists in the damper.

Press a new ring spacer inside the damper. The ring spacer

will ﬁt in tightly inside the damper and its outline should match

the proﬁle of the 1:1 pawl teeth.

TECHNICAL SERVICE