Installation manual

C L E A N M E C H A N I S M A S S E M B L Y

Thoroughly clean any contamination and grease from the components of the mechanism assembly. Ensure that any grease residue

is removed from the pawls, pawl seats, gear teeth, and the outer bearing and ensure these components are dry prior to applying

fresh grease.

GREASE AND REASSEMBLE MECHANISM ASSEMBLY

IMPORTANT:

Use only the grease provided in the HammerSchmidt grease kit inside the mechanism assembly. Poor performance and

accelerated wear may be expected from use of other lubricants.

Reassemble Carrier Assembly

Apply a generous amount of grease to the planet carrier

surface and planet posts.

Install the planet gears onto the planet posts. Grease should

ooze from underneath the planets as they are pressed against

the carrier.

Install new planet retaining rings. Be sure that these rings are

completely seated in their grooves by pressing the ends in

with a small screwdriver.

Apply grease to the teeth and exposed face of the planets.

TECHNICAL SERVICE