Installation manual

Bearing Seal Removal

Use a small ﬂathead screwdriver to remove the bearing seal by

gently prying upward from the inner edge of the seal. Perform

this step carefully to avoid bending or damaging the seal. If the

seal is damaged during removal, it should be replaced to avoid

creating increased drag and poor sealing performance.

Ring Spacer and Damper Removal

NOTE:

It is not necessary to remove the ring spacer and damper to service

the HammerSchmidt mechanism assembly. These parts should only

be removed for damper replacement to avoid damage from removal.

Use a pick and pry upward to lift out the ring spacer.

Use a pick to carefully pry the damper from the ring gear. The

damper is tightly ﬁtted into a groove on the ring gear and may

require ﬁrm pressure to position the pick for prying.

TECHNICAL SERVICE