Installation manual

D R I V E M E C H A N I S M A N D C R A N K

ARM INSTALLATION

Press the large shifter paddle to pull the actuator and retract

the pawls on the collar assembly. Apply grease to the drive

side bottom bracket splines and crank bolt threads. Use an 8

mm hex to install the drive side crank arm assembly, making

sure the spindle splines engage with the bottom bracket.

Tighten the crank bolt until it stops, and torque to 48-54 N·m

(425-478 in-lb).

N O N - D R I V E S I D E C R A N K A R M

INSTALLATION

Apply grease to the non-drive side bottom bracket splines and

crank bolt threads. Align the non-drive side crank arm to be

180° opposite the drive side crank arm. Use an 8 mm hex to

install the non-drive side crank arm, making sure the spindle

splines engage with the bottom bracket. Tighten the crank bolt

until it stops and torque to 48-54 N·m (425-478 in-lb). Check that

the crank arm contacts non-drive side crank stop (no gap). If it

doesn’t, you will need to remove the crank arm, apply

additional grease and re-install.

INSTALL CHAIN AND ADJUST CHAIN GUIDE

Size and install a new SRAM chain according to the installation

instructions. Use a 2,5 mm hex to adjust the location of the

chain guide if necessary. Make sure the chain guide does not

interfere with the chain when the rear suspension is fully

compressed.

48-54 N·m (425-478 in-lb)

INSTALLATION