Installation manual

I N S T A L L H A M M E R S C H M I D T

BOTTOM BRACKET

If you have a 68 mm bottom bracket shell, separate the two

parts of the bottom bracket and install the included bottom

bracket spacers, one over the drive side bottom bracket cup,

the other over the non-drive side bottom bracket up. This will

set the bottom bracket spacing to accommodate

HammerSchmidt.

Apply a liberal amount of grease to the bottom bracket shell

threads in the frame. If you haven’t already, pull the non-drive

side cup off the bottom bracket and apply a small amount of

grease to the cup threads. Carefully separate the center shell

from the drive side cup and apply a small amount of grease to

the o-rings on each side of the cup. Insert the center shell

back into the drive side cup. Finally, apply a small amount of

grease to the drive side cup threads.

spacer

grease

INSTALLATION