Installation manual

© SRAM LLC • 2010 TRUVATIV TECHNICAL MANUAL 13
4
If it is not already assembled, prepare the self-extracting crank bolt as illustrated.
Apply grease to the surfaces indicated. Use a 16 mm hex (5/8”) (10 mm hex for
Elitacranksets)toinstallself-extractingcrankboltandtorqueto12–15N•m
(106–133 in-lb).
INSTALLATION
5
Thread the drive side bottom bracket cup into the frame until the flange (or
spacer) contacts the bottom bracket shell face. Torque to 34–41 N•m (301–363
in-lb).
6
Thread the non-drive side bottom bracket cup into the frame until the flange (or
spacer) contacts the bottom bracket shell face.
Torque to 34–41 N•m (301–363 in-lb).
7
Apply grease to the inner bearing races as illustrated. Slide the right crankarm
assembly spindle through the drive side bottom bracket cup until the splines
come through the non-drive side bottom bracket cup and the spindle stops.
8
Assemble the left crank arm onto the bottom bracket spindle using an 8 mm hex
and torque to 48–54 N•m (425–478 in-lb).
Check the assembly for play by rocking the crank arms back and forth away from frame.
If the crank moves, tighten crank arm bolt until no play is detected. If maximum torque
of 54 N•m (478 in-lb) has been achieved, remove the crank arm from the spindle, apply
additional grease and repeat installation proceedures until play is eliminated.
16 mm (5/8“) / Elita - 10 mm
12–15 N
•m
106–133 in
-lb
GREASE
4
English
(BSA)
Italian
(IT)
34–41 N• m (301–363 in-lb)
5
GREASE
34–41 N• m (301–363 in-lb)
GREASE
6
GREASE
7
GIGA X PIPE BOTTOM BRACKETS AND CRANKSETS