Installation manual

Euphonix FC726 Format Converter Users Manual Introduction and Interface

Figure 1-3 FC726 front panel (right)

5. FORMAT B Sample Rate LEDs

These LEDs indicate the Format B sample rate. If the rate is not 44.1, 48, or 96 kHz

(±3%), the CUSTOM LED lights. Since the FC726 supports SRC, Format A may

operate at several sample rates that are not indicated by individual LEDs.

6. FORMAT B Sync Source LEDs

These LEDs shows Format B’s sync source. The blue button below the AUTO

LED manually toggles the sync source sequentially from AUTO to AES,

WORD, MADI, and FORMAT A. When set to AUTO, the FC726 accepts the

first sync signal detected with the following priority: AES, WORD, MADI, and

FORMAT A. For example, if MADI and Format A sync are both present, the

selected source will be MADI because it is higher in the priority list.

7. Power Switch

This switch turns power to the FC726 on or off.