Specifications

Chapter 2: New and Changed Features in S6 Software v1.4 4
Chapter 2: New and Changed Features in
S6 Software v1.4
S6 Software v1.4 includes the following new and changed features:
• “Input and Output Assignment Improvements” on page 4
• “Automation Trim Metering and Write Indication on Fader Modules” on page 6
• “New Preference Settings for Banking, Navigation and Display” on page 7
• “Home Screen Settings” on page 9
• “Page Switches on the Master Module” on page 10
• “Auto Talkback” on page 11
• “Displaying Names in Asian Characters” on page 11
• “Expand Mode Improvements for EQ and DYN Knob Sets” on page 12
• “Progress Indicators for Session Load and Workstation Connect” on page 13
Input and Output Assignment Improvements
(Requires Pro Tools 11.3.1)
With Pro Tools 11.3.1 and later, the Input and Output knob sets have changed to simplify signal routing.
Input Assignment
To assign track Input from the Master Module:
1 Attention a track to bring it to the Attention Track knobs.
2 Navigate to the Home screen and tap to select Input in the Function scroller. The upper left knob shows the currently assigned
input source.
3 Do any of the following:
• To exit without changing the current assignment, tap to select any other function in the Function scroller.
• To select a different source, press the upper left knob; the two upper left knobs display interface and bus sources, respectively.
Rotate the corresponding knob until the desired source is displayed, then press the
In switch for that knob.
• To return to the previous page of choices, press the Master Module
Back switch ( ).
To assign track Input from a channel strip:
1 In the strip for the desired track, press Input on the Process module. The top-most knob in the Knob Module shows the current
input assignment for the track (if no Knob Module is present for that strip, the current input assignment appears in the Process
Module encoder display).
2 Do any of the following:
• To exit without changing the current assignment, press any other Function switch.
• To select a different input, press the knob top showing the current input assignment. The top two knobs now show
interface
and
bus choices. Rotate the corresponding knob until the desired source is displayed, then press the In switch for that knob.
• To return to the previous page of choices, press
Back.
Be sure to check the S6 Software v1.4 ReadMe for additional information.