Specifications

Chapter 2: New and Changed Features in S6 Software v1.4 11
Auto Talkback
The Monitoring screen now provides its own Local Options, accessed by touching the Local Options (gear) icon.
To set Monitoring Local Options:
1 Press Setup in the Monitoring section of the Automation Module to go to the Monitoring screen.
2 Tap the Local Options icon (or press its Soft Key, below the icon), and set the following preferences as desired.
Auto Talkback
When enabled, the Talkback mic automatically shuts off when the Transport is playing or recording. When the Transport is
stopped, in shuttle, rewind or any mode other than play or record, Talkback turns on. Pressing the Talkback switch overrides this
setting.
Enable Surface Talkback Latching
When enabled, the Talkback switch operates in Latching mode if held down for less than 1/2 second (it stays in its current state until
the switch is pressed again).
Enable GPI Talkback Latching
When enabled, GPI-triggered Talkback operates in Latching mode if engaged for less than half a second (it stays in its current state
until the switch is triggered or pressed again).
Displaying Names in Asian Characters
You can specify an Asian language in which Channel names, memory locations and dynamic Soft Key names (such as Soft Keys
for memory locations or groups) are displayed using the new
Language setting in Settings > Preferences.
Tap to display the choices for language, then tap again to make a selection. After changing the Language setting, you must restart
the Master Module.
Figure 9. Monitoring Local Options icon
Figure 10. Language Preferences in Settings > Preferences.