Setup guide

The Avid MediaDock LVD
Workstation Setup Guide • 47
To connect the Avid MediaDock LVD in a three-enclosure configuration
1. Locate one of the SCSI cables in the Avid MediaDock LVD kit.
2. Attach the very-high-density connector of the cable to the channel 1/A
connector of the Adaptec controller.
3. Attach the cable’s other high-density 68-pin connector to the corresponding
connector in the SRM module at the top rear of Avid MediaDock LVD #1.
4. Locate the second SCSI cable; it is identical to the first.
5. Attach the very-high-density connector of the cable to the channel 2/B
connector of the Adaptec controller.
6. Attach the cable’s other high-density 68-pin connector to the corresponding
connector in the SRM module at the top rear of Avid MediaDock LVD #2.
7. Locate another SCSI cable that has high density 68-pin connectors at
both ends.
8. Attach one end of the cable to the connector on the I/O module at the
bottom rear of Avid MediaDock LVD #1.
9. Attach the other end of the cable to the I/O module at the bottom rear of
Avid MediaDock LVD #3.
10. Locate another SCSI cable that has high density 68-pin connectors at
both ends.
11. Attach one end of the cable to the connector on the I/O module at the
bottom rear of Avid MediaDock LVD #2.
12. Attach the other end of the cable to the ESM module at the top rear of
Avid MediaDock LVD #3.
13. On Avid MediaDock LVD #1 and #2, place the configuration switches on
the SRM and I/O modules into position 2.
14. On Avid MediaDock LVD #3:
• Place the configuration switch on the ESM module in position 1.
• Place the configuration switch on the I/O module in position 2.