Installation guide

46
➤ Bug Number: UDEV00132940 . You might see a “FluidMotion Vector Edit Requires Full
Resolution” error if you work in FluidMotion™ Vector Edit mode in anything other than full
resolution (green mode in the Timeline). Render FluidMotion effects before you combine
them with any other effects, especially any other time-based effects.
➤ Bug Number: . (Progressive projects only) If a clip contains any of the following effects,
you must render the effects before you apply Scratch Removal:
• Timewarp effects
• Any effect that has been promoted to the Advanced Keyframe model
➤ Bug Number: UDEV00134286. Removing or undoing some timewarp effects might cause
audio and video to lose sync.
➤ Bug Number: UDEV00161774 . In the Transition Corner Display mode, two of the six
frames display incorrect frames during trim operations initiated from the Timeline.
Workaround: Trim using the Trim buttons.
➤ Bug Number: UDEV00144549. The Fluid film 2:3 timewarp effect might render
incorrectly when you are rendering fluid motion type. The effect might flash a crop of left
and right edges.
Workaround: Set the left and right mask in the FluidMotion Editor to zero.
➤ Bug Number: UDEV00164929. (HD only) Any animated alpha matte over 35 seconds long
might fail.
➤ Bug Number: UDEV00163592. When an Avid effect is applied in an SD 24p progressive
project, it can create unwanted aliasing on the resulting clip.
Effects (Pan & Zoom)
You might encounter the following limitations when you use the Pan & Zoom effect:
➤ Bug Number: UDevC00119611. If you run out of memory when using Pan & Zoom, resize
the images to a lower resolution using an application such as Adobe Photoshop software.
➤ Bug Number: UDevC00088408. (Macintosh) After the link to a Pan & Zoom effect is
broken and you want to reestablish it, the application doesn’t prompt you for the source
image name in the Open dialog box.