Installation guide

40
Mac Intel® based systems. Customers may need to upgrade their AudioSuite and AVX
plug-ins. Please note that Avid has informed Third Party partners of this change. Third Party
plug-ins that have not been updated will not be supported in this release.
➤ Bug Number: UDevC00079523. If you are a non-administrator and you want to launch
AudioSuite Plug-Ins, make sure you have an administrator make you a member of the
AvidUsers group which is automatically created during installation.
➤ Bug Number: UDEV00219672. You currently cannot select HDV projects in the
MediaLog™ application.
➤ Bug Number: UDEV00164891. (NewsCutter Software Only) When working with the
HP/Compaq nw8000 laptop, if you press the volume button (which is located on the front of
the laptop, not on the keyboard), this causes an overwrite in the source/record edit to the
Timeline.
➤ Bug Number: UDEV00141328. Sending to Digidesign
®
Pro Tools: When you export an
OMF 2.0 file that links to MXF media, you should first transcode the MXF Media to OMF
media. If you have a long sequence containing MXF media, you are not prompted prior to
the export process that the export will not be successful. To save time, transcode MXF media
to OMF media prior to exporting as OMF 2.0.
➤ Bug Number: UDevC00091387. Due to an issue with the RICOH FireWire controller on
the Dell M65 and M90 laptops, when playing out to the host in 1394 mode, as well as a DV
device via the “Output to DV Device” option, video and audio may drift out of sync.
Workaround: Turn off “Output to DV Device.” Or, if you have to use the DV Device for
monitoring, connect the speakers or headphones to the DV device/camera instead of the PC.
➤ Bug Number: UDevC00120475. Editing keyboard shortcuts such as Ctrl+X and Ctrl+C do
not work in MetaSync Manager. Use the menu commands.
Digital Cut
➤ Bug Number: UDevC00102676. When performing a digital cut, you will receive the
message “If you have a genlock signal connected to your BOB, please switch it to match the
output rate. Use an appropriate black burst sync source. Then wait for the REF light on the
BOB to turn green and press Continue.” If the light turns green, press Continue and the
digital cut will be performed. If not, make sure an appropriate sync source is connected and
wait for the REF light to turn green.