Installation guide

Limitations and Known Issues
35
➤ Bug Number: UDEV00220761. When you capture from an HDV device through 1394 into
an HDV interlaced project, you might see the video break up into squares. The captured
media is intact and complete, however.
➤ Bug Number: UDEV00197055. When you capture media that includes invalid frames, you
might see an error message that the capture has been aborted and the invalid frames
discarded and it asks you if you want to keep the clip. This message is incorrect; the invalid
frames have not been discarded.
Workaround: Click No to discard the clip, and then recapture using new marks that
exclude the bad sections on the tape. Do not keep the clip.
➤ Bug Number: UDEV00204777. When you deselect Enable Confidence View in the Video
Display Settings dialog box and then open the Capture tool, the Client monitor does not
display passthrough.
Workaround: Do one of the following:
t Select Enable Confidence View.
t Click the Capture button in the Capture tool.
➤ Bug Number: UDEV00184515. In an HDV project, you can only capture audio at the 48k
sample rate. Because the incoming audio is digital over FireWire
®
, the software is unable to
up-sample 32k and 44.1k audio reliably during capture. If you try to capture audio at another
sample rate, you do not receive the error message warning that the audio on the tape does not
match the setting in the Audio Project Settings dialog. Currently, only the 48k sample rate is
supported in the HDV project format.
➤ Bug Number: . If you lose connection to your 1394 port or receive “OHCI Port Busy”
errors, check the FireWire cable length.
➤ Bug Number: . When you capture HDV, the system might not find the preroll point if the
Preroll setting is set to 3 or below. The default is set to 6. Do not set this option to 3 or below.
➤ Bug Number: UDEV00183907. (HDV) Passthrough does not work if Delay Audio is set to
7 frames or greater. (The Delay Audio option appears in the Capture tool.)
Workaround: Set Delay Audio to 6 or fewer.
➤ Bug Number: UDEV00181815. Drop frame/Non-drop frame mismatch errors occurred
often when capturing. A new Deck Preference setting has been added. Access the Deck
Preferences Settings dialog box. A new “When the deck contains no tape Log as” option