Installation guide

32
3. Ensure that the Record/Input descriptions match the Playback/Output settings. For
example, if you have a microphone plugged into the rear pink connector, then the
Playback/Output option should be set to Rear Pink In. If you have a Line input audio
device connected to the front black connector, the Playback/Output option should be set
to Front Black In.
➤ Bug Number: UDEV00143962. Clip Pan: When you add an audio dissolve between two
clips with Clip Pan onto a single audio track, the audio dissolve uses the Clip Pan setting on
the outgoing source for the duration of the dissolve.
➤ Bug Number: UDevC00118578. Occasionally, you might receive a “ReadStreamAsyn”
error when performing a Digital Audio Scrub. If you continue scrubbing, the audio will
come back.
➤ Bug Number: . Pan Automation (overrides Clip Pan when applied): When you add an audio
dissolve between two clips with Automation Pan onto a single audio track, the audio
dissolve interpolates the pan values between the pan keyframe value at the beginning of the
dissolve and the pan keyframe value at the end of the dissolve. Any pan keyframe that exists
in the middle of the dissolve is ignored.
Workaround: Place the two clips on separate tracks using Clip Pan, fade one to silence,
and fade the other up from silence.
➤ Bug Number: . The following procedure causes a failure in the audio output: Open a
720p50 HD project, open the Capture tool and select HD-SDI video and Audio input.
Capture an HD Clip from Satellite source using HD-SDI Embedded feature and save it to a
Bin. Create an HD sequence using the above saved HD clip. Configure the Panasonic HD
150, and set the deck to accept HD-SDI audio Embedded. Open the Video output dialog.
Turn on HD-SDI Audio Embedded. Attempting to output an HD sequence (Preview) to an
HD deck using HD-SDI audio Embedded feature completely fails. There is no audio output
signal seen on Deck.
➤ Bug Number: UDEV00207753. The Panasonic HD150 deck will not decode the HD
embedded audio stream from Adrenaline or Avid Nitris.
Workaround: Connect AES audio from the Avid DNA hardware to the deck and disable
the embedded audio.
Audio Punch-In Tool
➤ Bug Number: UDEV00086862. You could monitor input during preroll in previous
versions. If you have a software-only system, you can still monitor input during preroll. If
you have an Avid Mojo, input monitoring begins at the IN point, not during preroll.