User guide

Chapter 4: Using S3 with Pro Tools 38
Working with Sends
This section shows how you can assign and adjust Pro Tools sends.
Assigning Sends
Use Channel Control to assign sends. You can also assign a send to multiple tracks using the Multi Assign switch (Do to Selected).
To assign a send using Channel Control:
1 Select a track, and make sure it is attentioned.
2 From the Channel Control top-level Knob Set, press the Sends Channel Control Encoder.
The Channel Control displays now show available Sends slots
a–j.
3 Press Config so it is lit. CFG appears in the Channel Control displays.
4 Press an Encoder under the display showing the send you want to assign. The first three Channel Control Encoders now display
the following output path types:
• no output
• interface
• bus
5 Press the Channel Control Encoder under the display showing the output path type you want to assign to the send. Up to 16 avail-
able output paths at a time are shown in the Channel Control displays.
6 Navigate to additional output paths by pressing < PAGE or PAGE >, where applicable.
7 To assign an output pair such as a stereo bus, press the Channel Control Encoder In switch under the corresponding display.
8 To assign a mono output, do the following:
• Press the Channel Control Encoder under the display showing the bus pair. Each individual bus is assigned to its own Channel
Control Encoder.
• Press the Channel Control Encoder
In switch under the corresponding display to assign the bus.
9 Press Config so it is unlit to exit Config mode.
If the top-level Channel Control Knob Set is not shown, press the Back Channel Control Navigation switch until it is shown.
Inserts top-level Knob Set in Config mode
Inserts
1
Kick
Input Dyn
EQ Sends Pan Groups Mix
a
1
Kick
b c
CFG CFG
CFG