User guide

Eleven Rack User Guide36
If you prefer to use the amp simulations in
Eleven Rack to set your tone, you will want to
send the signal just after the amp simulation,
but before the cabinet simulation, to your am-
plifier.
To set the type of signal to send to the amp:
1 Press and hold the Edit/Back button to show
the User Options mode.
2 Scroll to Outputs To Amp with the Scroll wheel.
3 Press SW1 to enter the Outputs To Amp
screen.
4 Choose the output you plan to use to feed the
amp, with the Scroll wheel.
5 Set the Signal control to one of the following,
using the first lit Control knob:
• Rig Input (no processing)
• Amp Input (pre-amp effects only)
• Amp Output (pre-amp effects and amp simu-
lation)
• Rig Output (all processing)
• Rig Out No Cab (all effects and amp simula-
tion, no speaker or microphone simula-
tion)
6 Press Edit/Back twice to leave User Options
mode.
When the Signal control is set to Rig Output
or Rig Out No Cab, the Rig Volume setting
no longer has any effect. Output volume
must be set using the To Amp controls in
the Output section in Rig View.
The signal level running to each Output To
Amp output can be set on a per-rig basis in
the Output section in Rig View or in the
Eleven Rack Control window. For more de-
tails, see “OUTPUT” on page 17, or “Out-
put to Amp Selectors” on page 82.
Because Eleven Rack simulates various pre-
amps and tone circuits, you may want to by-
pass your amp’s preamp and tone circuitry
by plugging into the amplifier’s effects re-
turn jack(s), if available, rather than the
standard input(s). If your amp does not
have an effects loop, try setting the amp
controls for maximum transparency (EQ
flat, gain stages set to clean.)