User guide

Chapter 3: Exploring Rigs 19
Control Pages
When there are additional controls available for
the device or utility setting you’ve selected,
pressing SW1 (labeled CONTROLS) takes you to a
special editing screen for that device, called a
Control page.
The Control knobs that are assigned to controls
in the current device will light amber, if you’re
editing Amp, Cab, or FX Loop settings, or green,
if you’re editing an effect. The display shows
what parameter each knob is assigned to, and
each knob’s current setting.
When you turn a knob away from its saved set-
ting, it will light red, to show you that the set-
ting has changed. If you want to return a control
to its saved setting, turn the knob until it goes
back to amber or green.
SW1 and SW2 are assigned to various functions,
like BYPASS, which toggles the current element
on and off, and other switched behaviors, like
BRIGHT (bright switch) and TREMOLO (tremolo
on/off).
If there is more than one page of controls avail-
able for the current device or utility setting, a
Page indicator is displayed. Turn the scroll
wheel to switch between pages. You can also use
the Scroll wheel to scroll quickly through all of
the Control pages in the current Rig.
When you’re finished editing, press Edit/Back to
go back to Rig View.
Saving Your Work
When you’re done editing the current Rig, you
may want to save its settings, or save the new
settings to a different user Rig without affecting
the current Rig.
Keep in mind that if you switch to another Rig
before saving your work, the edits you’ve made
will be lost.
To save the new settings to the current Rig:
1 Press the Save button. The display will show
the Save View.
2 Press Save again to save the updated settings
to the current Rig.
Control page for Green JRC OD effect
Individual effects may be toggled on and off
at any time by pressing the corresponding
Effects Control button on the front panel of
Eleven Rack. The Wah effect can be toggled
on and off by pressing FX1 and FX2 simul-
taneously.
Save page