User guide

Chapter 10: User Options 95
When Eleven Rack is plugged into a computer
with USB for use with Pro Tools LE.
Pro Tools HD or Pro Tools M-Powered, these op-
tions must be set in the host software (Pro Tools
LE or other). The Digital Clock/Input screen will
just show the current settings and whether or
not there is a valid clock signal present at the
currently chosen digital input.
Digital Output
Adjust the Output control to choose the type of
signal being passed to the digital outputs.
DAW The output from the Digital Out L/R out-
put path in Pro Tools LE will be sent to the digi-
tal outs.
Mirror Analog The same signal that is being sent
to the Main Outputs will be sent to the digital
outs.
Rig Outputs The left and right Rig outputs are
sent to the left and right digital outputs respec-
tively.
Split In/Out The left and right Rig outputs are
summed and sent to the left digital output, and
the signal as present at the Rig input (the “dry”
signal) is sent to the right digital output.
FX Loop
The FX Loop screen is where you control the
mono/stereo behavior of the FX loop. Set the
control to Mono if using a mono effect, to Mono
to Stereo, if using an effect that takes a mono
signal but has a stereo output, or Stereo, if using
a true stereo effects unit.
External Pedals
This screen lets you set up an expression pedal
or a dual footswitch, plugged into the Exp
Pedal/Ext Footswitch jack on the back of Eleven
Rack.
Turn the Scroll wheel to select the type of pedal
you’ll be using. In expression pedal mode, you
can press SW1 to enter calibration mode. Follow
the on-screen instructions to calibrate your ex-
pression pedal. In Dual Footswitches mode, you
can use the Tone Control knobs to select a func-
tion for each footswitch.
Each footswitch can be set to do one thing,
whether it’s cycling through Rigs, turning a cer-
tain effect on and off or just bringing up the
tuner.
MIDI
The MIDI page lets you set up how Eleven Rack
responds to MIDI data.
Channel Sets the MIDI receive and send channel,
from 1-16.
Thru Toggles MIDI thru on and off.
CC When engaged, front-panel control changes
will send corresponding MIDI CC messages to
Pro Tools, and be output through the MIDI out-
put jack.
For more information on how to access
these controls from within Pro Tools LE, see
“Pro Tools Hardware Settings” on page 59.