User`s guide

File Gateway Server
13
File Gateway Server Rear Connections
The following figure shows the rear panel of the File Gateway server and the function of
each connection.
File Gateway Server Rear View
D Four green network activity
LEDs
Illuminates green when a good network connection is established and
blinks when there is network activity on the four built-in 1 GB
network ports.
The number beside the LED corresponds with the number beside the
network port on the rear of the enclosure. For example, Connector 1
is LED 1 on the front. See
“File Gateway Server Rear Connections”
on page 13
.
E Red System error LED Illuminates red when an error is detected with the system (fan, power
supply, temperature, voltage).
F System Drive activity LED Indicates drive activity from the onboard SATA controller and blinks
when either of the system drives is being accessed.
G System ID button When pressed it illuminates (blinks) blue and also illuminates an
LED on the rear of the enclosure. The rear LED is also blue and is
visible on the lower left-hand side of the Ethernet ports inside of the
enclosure. It is used to identify a system for servicing when it is
installed in a high-density rack/cabinet populated with several other
similar systems.
H Power button Press to turn on the enclosure. Power button illuminates green when
the power is on.
File Gateway Server Panel
Letter Component Description
Power supplies
Slots not used
Serial Intel Pro Ethernet ports VideoUSB