Setup guide

34
ISIS Client Manager Settings
The Interplay Software Installation and Configuration Guide describes how to set ISIS
Client Manager settings and how to configure a Chelsio card as the default network
connection. These operations are NOT required for the Myricom cards.
Migrating a Move Provider
This topic describes how to set up the hardware and ISIS client information for a Move
Provider on an AS3000 server. The Move provider is used to move files from one ISIS
workspace to another.
n
The Move feature works only within a single workgroup with a single ISIS System Director.
To copy assets and media to a different workgroup, use the Copy Provider.
The AS3000 has two PCIe slots and both support the Myricom cards. The appropriate
drivers are pre-loaded onto the AS3000 image for Windows 7 Pro 64-bit. The Move Provider
only requires one Myricom card. You can install it in either slot.
To install the Myricom card:
1. Install the card in the either of the two PCIe slots as described in the AS3000 Setup
Guide. For convenience, use the bottom slot.
2. Reconnect and restart the system. The system automatically recognizes the Myricom
card because the drivers are pre installed on the Windows 7 Pro recovery image.
For an illustration shows that shows the Myricom card in the Windows Device Manager,
see “Migrating a Copy Provider” on page 31.
If you find it necessary to locate the Myricom drivers, the Myricom drivers folder is
located in the following location:
C:\Installables\drivers\nic
12
34
Two PCIe slots
PRO/1000 PT ports