Setup guide

Replacing a Power Supply

To replace a power supply:

1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on

page 37 and “Safety and Regulatory Information” on page 70.

2. Power down the server and unplug all peripheral devices and the AC power cables.

The power supply must be unplugged before you remove it.

3. Push the latch towards the handle and remove the power supply by pulling on the handle.

Removing a Power Supply

A. Latch

B. Handle

4. Insert the replacement power supply module into the power supply cage until it clicks into

place.

5. Reconnect all peripheral devices and the AC power cords into the server. Note that the

AS3000 will power up without having to turn on the power switch.