Setup guide

Replacing a Power Supply
56
11. Replace the processor air duct and system cover. See “Removing and Installing the
Processor Air Duct” on page 51 and “Removing and Installing the System Cover” on
page 45.
12. Reconnect all peripheral devices and the AC power cords into the server.
To remove DIMMs:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 37 and “Safety and Regulatory Information” on page 70.
2. Power down the server and unplug all peripheral devices and the AC power cables.
3. Remove the server system cover. See “Removing and Installing the System Cover” on
page 45.
4. Remove the processor air duct. See “Removing and Installing the Processor Air Duct” on
page 51.
5. Gently spread the DIMM socket retaining clips at each end of the socket. The DIMM lifts
from the socket.
6. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static package.
7. Replace the processor air duct and system cover. See “Removing and Installing the
Processor Air Duct” on page 51 and “Removing and Installing the System Cover” on
page 45.
8. Reconnect all peripheral devices and the AC power cords into the server.
Replacing a Power Supply
The AS3000 is designed to run with two operating power supplies. A power supply can be
replaced if it fails. If a power supply fails, the LED on the power supply and the front panel LED
turn red and a beeping alarm sounds. The alarm is not configurable.
c
A power supply is only hot-swappable if the other power supply is operational. If you only
have one power supply working, before removing or replacing that power supply, you must
first take the server out of service, turn off all peripheral devices connected to the system,
turn off the server by powering it off from the Start menu. Then unplug the AC power cord
from the system or AC outlet.
c
Avid recommends the use of uninterruptible power supplies, appropriately sized for your
AS3000. This provides protection against sudden power surges or losses that could cause
you to lose files or experience data corruption. See “Uninterruptible Power Supply (UPS)”
on page 68.