Setup guide

Removing and Installing the Processor Air Duct

4. Loosen the three screws holding the processor air duct tabs to the chassis.

Removing the Processor Air Duct

A. Processor air duct screws

5. (Option) Leave the completely loosened screws sitting on the tabs. Then you can lift the

processor air duct and the screws out of the chassis at the same time.

6. Carefully lift the processor air duct from the chassis.

To replace the processor air duct:

1. Carefully insert the processor air duct into position.

2. Insert the three screws into the holes in the processor air duct tabs

3. Tighten the three screws loosely while adjusting the processor air duct.

4. Once the air duct is correctly seated, finish tightening all three screws.

5. Replace the system cover. See “Removing and Installing the System Cover” on page 45.

6. Reconnect all peripheral devices and the AC power cords into the server.