Setup guide

Removing and Installing the System Cover
45
12. When the black drive carrier lever begins to close by itself, push on it to lock the drive
assembly into place. This seats the drive in the AS3000. You’ll hear a click when the drive is
fully seated and the lever latches in place.
Install Drive Assembly into the Server System
A. Latch button and black lever
13. Use a drive lock key to lock the drive in place. See “Locking and Unlocking a Drive” on
page 40.
14. Repeat the steps for any additional drives that must be added,
15. Plug all peripheral devices and the AC power cables into the server.
Removing and Installing the System Cover
The server system must be operated with the chassis cover in place to ensure proper cooling. You
will need to remove the top cover to add or replace components inside of the server. Before
removing the chassis cover, power down the server and unplug all peripheral devices and the AC
power cables.
n
A nonskid surface or a stop behind the server system may be needed to prevent the server system
from sliding on your work surface.
To remove the system cover:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 37 and “Safety and Regulatory Information” on page 70.
2. Turn off all peripheral devices connected to the server. Turn off the server.
AA