Setup guide

Removing and Installing a Hot-swap Hard Drive

8. Remove the new hard drive from its wrapper and place it on an antistatic surface.

9. With the label side up, position the connector end of the drive so that it is facing the rear of

the drive carrier.

10. Align the holes in the drive to the four holes in the side of the drive carrier and attach it to the

carrier with the four screws. Make sure that the SATA connector is not blocked by the metal

tray.

If you are installing a drive for the first time, use the screws that were included in the AS3000

accessory kit. See “Avid AS3000 Server” on page 18.

Installing Hard Drive into Carrier

A. Attach two screws on each side of the carrier.