Setup guide

Removing and Installing a Hot-swap Hard Drive

Locking a Drive

A. Drive lock key

4. Store the key in a secure location for future use.

To unlock a drive:

t Insert the key into the drive carrier lock and turn it counter-clockwise to unlock the drive.

Removing and Installing a Hot-swap Hard Drive

This section describes a generic procedure for installing or replacing hot-swap hard drives on the

AS3000. For additional information, see “Replacing System Drives in the AS3000” on page 38.

To removing and install a hot-swap hard disk drive:

1. If necessary, remove the front bezel. See “Installing and Removing the Front Bezel” on

page 29.

2. Unlock the drive. See “Locking and Unlocking a Drive” on page 40.

3. Press in on the button on the latch at the front of the hard drive carrier. See Letter A in the

figure below.