Setup guide

Connecting to an Ethernet Network
31
Connecting to an Ethernet Network
You can connect the AS3000 to an Ethernet network using the four 1 Gb Ethernet ports on
the rear of the enclosure. Please note that some Avid applications require the use of one or
both of the PRO/1000 PT ports (Ports 2 and 4). For additional information, see your Avid
product documentation.
n
Avid does not install, configure, or troubleshoot in-house LANs. If you are having trouble
with your LAN, consult your Information Services department or your network vendor.
c
When you are connecting the AS3000 to an Ethernet network, make sure you use only
Category 5E, 6, or 6A Ethernet cables. Using other cable types can cause performance
problems.
Turning On the Avid AS3000 Server Hardware
To turn on the AS3000 Server hardware:
1. Push the power button at the top left on the front of the your server, see “Avid AS3000
Front Panel and LEDs” on page 12.
n
On a newly-imaged system, you can log in as Administrator with a password of is-admin.
n
The server BIOS is configured to automatically power up the system after power is restored
to one or both power supplies following the loss of power to both power supplies.