Setup guide

2 Installing the AS3000 System
22
Attaching Inner Slide Rails to the Avid AS3000 Server
Attach the inner slide rails that were separated from the outer slide rails to the AS3000.
To attach the inner slide rails:
1. Position the inner slide rail against the side of the server so that the spring clip end is
toward the rear of the server. The hole in the front of the inner slide rail fits over the tab
at the front of the server.
2. Secure the inner slide rail to the server with two of the small (M4x5) screws.
n
You might find more screws in the rail kit than are described in this procedure.
Attaching the Inner Slide Rails
3. Repeat this procedure to attach the second inner slide rail on the other side of the server.
Attaching the Outer Rails to a Square-Hole Rack
After separating the slide rails as previously described (see “Separating the Slide Rails” on
page 21), perform one of the following procedures. If your mounting rails have round holes,
see “Attaching the Outer Rails to a Round-Hole Rack” on page 25.
To attach the outer slide rails to a square hole rack:
1. Align the front of the outer slide rail bracket assembly with the front rack-mounding
holes.
n
You should have someone helping you hold the slide rails level while you are positioning
them in the rack.