Setup guide

AS3000 Hardware
13
D Four green network activity
LEDs
Illuminates green when a good network connection is established
and blinks when there is network activity on the four built-in 1-Gb
Ethernet ports.
The number beside the LED corresponds with the number beside the
Gb Ethernet port on the rear of the enclosure. For example,
Connector 1 is LED 1 on the front. See “AS3000 Rear Panel” on
page 14.
E Red System error LED Illuminates red when an error is detected with the system (fan,
power supply, temperature, voltage).
F System Drive activity LED Indicates drive activity from the onboard SATA controller and blinks
when either of the system drives is being accessed.
G System ID button When pressed it illuminates (blinks) blue and also illuminates an
LED on the rear of the enclosure. The rear LED is also blue and is
visible on the lower left-hand side of the Ethernet ports inside of the
enclosure. It is used to identify a system for servicing when it is
installed in a high-density rack/cabinet populated with several other
similar systems.
H Power button Press to power on the enclosure. Power button illuminates green
when the power is on.
System Control Panel
Letter Component Description