Product specifications

Installing the Interplay | Engine on the First Node
81
To specify the Interplay Engine details:
1. Type the following values:
- Virtual IP address: This is the Interplay Engine service IP Address, not the Cluster
service IP address. For a list of examples, see “List of IP Addresses and Network
Names” on page 31
.
For a dual-connected configuration, you set the other public network connection after
the installation. See
“Adding a Second IP Address (Dual-Connected Configuration)” on
page 96
.
- Subnet Mask: The subnet mask on the local network.
- Public Network: For a redundant-switch ISIS configuration, type Public, or whatever
name you assigned in
“Renaming the Local Area Network Interface on Each Node” on
page 39
. For a dual-connected ISIS configuration, type the name of the public network
on the first node, for example, Left, or whatever name you assigned in
“Renaming the
Cluster Networks in the Failover Cluster Manager” on page 61
. This must be the cluster
resource name.
To check the name of the public network on the first node, open the Networks view in
the Failover Cluster Manager and look up the name there.
- Shared Drive: The letter of the shared drive that is used to store the database. Use S: for
the shared drive letter.
c
Make sure you type the correct information here, as this data cannot be changed
afterwards. Should you require any changes to the above values later, you will need to
uninstall the server on both nodes.
2. Click Next.
The Specify Interplay Engine Name dialog box opens.