User guide

Artist Transport User Guide6
Removing the Riser Brackets
To remove the riser brackets from Artist Transport:
1 Slide the side panel towards the front of the unit, then pull it away.
2 Press the tabs to release the riser bracket and lift it out of the side panel.
Attaching an Artist Transport to Additional Units
Artist Transport can be physically attached to other Artist Series units to form a larger and more stable control surface.
To join Artist Transport to other Artist Series units:
1 On the Artist Transport, use a #2 Phillips screwdriver to remove the two silver screws. The screws may be tight, so you may have
to use some force.
2 Lift the black plastic connecting part and side panel up and out of the Artist Transport.
Removing side panel
Tabs to release the riser bracket from the side panel
If you are using multiple units, see “Surfaces” on page 27 to use EuControl to link the units in the desired order.
Removing screws from the bottom panel
Removing connecting part and side panel