User guide
Chapter 3: Artist Transport Operation 15
In some applications, the Jog Wheel can act as an Assignable Knob. This lets you use the Jog Wheel to adjust the values of any
control the cursor hovers over in Cubase or Nuendo, such as faders, pan knobs and plug-in controls. Other applications require
a mouse-click on the control to allow adjustment (such as Logic Pro).
The Jog Wheel can also be used to adjust control room volume for certain applications (such as Studio Monitor Express, Cubase,
and Nuendo).
The Jog Wheel can be programmed to generate a Custom Command to send keystrokes into the application. See “Custom Jog
Command” on page 23.
All Wheel functions (including positioning, zooming, trimming, Assignable Knob, Control Room Volume, and Custom) are ini-
tiated by pressing an assignable key.
Shuttle Ring
The Shuttle Ring lets you shuttle through the session or project timeline. The farther it is turned, the faster it shuttles. The Shuttle
Ring can also have different functions assigned. See see Chapter 4, “Soft Keys” for more information.
Application/Workstation Key
The Application/Workstation key lets you quickly toggle Artist Transport focus between the two most recently used applications,
or cycle through all open applications. This key also lets you use the Artist Transport to control applications running on a second
computer (referred to in this guide as a workstation).
To toggle between the two most recently used open applications:
Press the Application/Workstation key.
To cycle through all open applications:
Hold down the Application/Workstation key and turn the Jog wheel in either direction.
To control an application on a different computer:
1 Use EuControl software to create a list of “workstations” to switch between.
2 Press and hold the SHIFT key and press the Application/Workstation key to attach Artist Transport to another workstation. While
attached to a second workstation, your keyboard and mouse can be configured to control the additional workstation and not
your primary workstation.
For more information on how to set up these programmable functions in EuControl and which applications allow them, see Chapter 4, “Soft
Keys.”
Application/Workstation key
See “Workstations” on page 29 for more information.
See “Redirect Keyboard and Mouse Control to Attached External Workstation” on page 30 for more information.