Specifications

Chapter 3: Basics 31
4 Press the encoder below the desired output assignment as follows:
• If you select
no output, the assignment is made and that encoder ON key lights.
• If you select
output or bus, Output bus and internal bus choices are listed above each Soft Encoder.
Press the
< PAGE and/or PAGE> keys to navigate to other output choices.
5 When the desired output is displayed, press its Soft Encoder. That encoder ON key lights.
6 To exit output assign mode, press any other Knob Set selector (such as PAN).
Multiple Output Path Assignments
Pro Tools tracks can have multiple output paths assigned to them. When assigning track output from a EU-
CON unit, repeat the previous instructions and the new assignment will be added to the current assign-
ments. When reassigning, you must first assign
no output, then assign a new output path.
To reassign track output on Artist Mix:
1 Select a channel by pressing its SEL key.
2 Press SHIFT+PAN/MIX. The display shows the output assignment for each banked track.
3 Press the encoder for the track you want to assign.
4 Press the encoder for no output (encoder 1). The assignment is made and that encoder ON key lights.
5 To exit output assign mode, press any other Knob Set selector (such as PAN).
6 Repeat these steps and assign the new output path.
Accessing Instrument Track Controls
Artist Control
To access and adjust Instrument track controls (such as MIDI Input and Output) from Artist Control:
1 Select a track.
2 Make sure no other mode is currently selected for the Touchscreen (press SHIFT+BACK/TOP to jump
back to the top level).
3 Press PAGE> to display the next page of modes.
Display no output output bus
Soft Encoder 1 2 3