Setup guide

Preventative Maintenance
83
7. Select the Boot Device Priority menu. Then, do the following:
t Make sure the 1st Boot Device displays the UFD that you changed to on the Hard Disk
Drives menu.
8. Press F10.
You will be asked if you want to Save configuration changes and exit setup.
9. With Ok selected, press Enter to save your configuration settings, and reboot the system.
The AvidPE Restore Menu opens. The Avid PE Restore Menu is often behind another
window. So, click it to make it the active window.
10. In the Enter a choice? field, type 2 to recover both the C: and D: partitions (the entire system
disk), and press Enter.
11. Type Y to confirm any changes.
The Symantec Ghost opens, and will display the progress of the image restoration. When it
is finished, you will get a message in the Recovery Complete dialog box saying “Drive
Image Completed Successfully.”
12. Press S to shutdown your system.
n
If the AirSpeed 5000 does not shut off when pressing the Power button, unplug the power supply
to the AirSpeed 5000. Make sure it powers down, and then plug it back in.
13. Unplug the UFD device from the USB port.
n
If any device, including the UFD, is left plugged in, the drive-lettering script could fail.
14. Re-insert the ten media drives into the AirSpeed 5000 chassis.
15. Press the Power button again to restore power to the AirSpeed 5000.
The system will begin to startup.
n
If the System Settings Change dialog box opens, it might be because of the USB device that was
plugged in. Click No to close the dialog box.
16. Press the Delete key during startup to enter the system BIOS again.
The BIOS SETUP UTILITY opens.
17. Navigate to the Boot Tab, and select Hard Disk Drives. Then, do the following:
a. Change the 1st Drive back to RAID: Intel Volume0, and press Enter.
b. Make sure the 2nd Drive is set to Media Drive.
Example: (BUS 82 DEV00) PCI RAID Ad.
c. Press ESC to return to the Boot tab.