Setup guide

Shared Storage and Device Service Checklist

The following table provides a checklist of tasks that must be performed when configuring the

AirSpeed 5000 server’s shared storage, and Device Service, if you’re site uses Avid iNEWS

Command to control AirSpeed 5000 channels.

Configuring Your Shared Storage (Interplay Production and Team Modes

Only)

If you will be using AirSpeed 5000 with Shared storage (with or without Interplay), you must

configure your shared storage for ISIS 5000 or ISIS 7000.

If you are using a Standalone Transfer Manager, you do not have to perform this procedure.

To configure your shared storage:

1. Install the Avid ISIS client software on the AirSpeed 5000 server.

2. It is recommended that you mount the volume that you intend to capture to using UNC based

mounting, via the ISIS client.

Some DNxHD resolutions with a higher count of audio channels and proxy enabled require two

connections to ISIS 5000 or ISIS 7000. In addition, the ISIS client must be set at “High

Resolution” to sustain the performance needed to handle four channels of simultaneous capture.

For more information on how to configure your shared storage, see the Avid Unity ISIS Setup

Guide.



(For Interplay Production, and Team modes only) Configure your shared storage, as

described in the topic “Configuring Your Shared Storage (Interplay Production and Team

Modes Only)” on page 77.



(Option) If using iNEWS Command, Interplay Capture, or Capture Manager to control

AirSpeed 5000 channels, you must install and configure the AirSpeed Multi Stream Device

Service, as described in the topic “(Option) Installing the AirSpeed Multi Stream Device

Service” on page 78.