Setup guide

3 Configuring the AirSpeed 5000 for Your
Network
This chapter describes network and Windows operating system parameters that need setting
along with instructions on how to configure your AirSpeed 5000 server for your network.
Once you have cabled up your AirSpeed 5000 server, and the system is powered on, you must
configure your operating system and set up your shared storage (for Interplay Production and
Team modes). Once that is done, assign an IP address, and activate your Operating System.
Your Avid AirSpeed 5000 ships with the Windows 7 Embedded 64-bit operating system
installed. If you need to re-image the operating system (OS) drives with the Windows operating
system see “Re-imaging Your System” on page 81.
n
Log on as amsuser and is-admin as the password.
n
Some USB flash devices might not appear in a Safely Remove Hardware dialog box even though
they are plugged in. In addition, it might take several seconds for a USB device to be available to
the system.
This chapter contains the topic AirSpeed 5000 Network Configuration Checklist.