Setup guide

Turning On the Avid AirSpeed 5000 Server
56
Turning On the Avid AirSpeed 5000 Server
When you turn on the power to your Avid AirSpeed 5000 server, you must do it in the following
order so that Avid AirSpeed 5000 will see all of its connected components.
To turn on the power for each component:
1. Make sure to turn on the power to the KVM switch (if using one).
2. Make sure you have all your network cables connected before you load the Avid AirSpeed
5000 software.
3. Push the power button at the top left on the front of the your AirSpeed 5000 server, see “Avid
AirSpeed 5000 Server - Front Panels” on page 6.
4. Wait for the Windows operating system to load before you attempt to use the Avid AirSpeed
5000 software.
5. Log onto the AirSpeed 5000 server.
n
Log on as amsuser and type is-admin as the password.
6. Your next step is to perform system diagnostics to make sure your system hardware is
healthy and working properly.
n
For information on performing system diagnostics, see “Performing System Diagnostics” on
page 57.