Setup guide

Cabling Up the AirSpeed 5000 Server
49
Connecting LTC
This topic contains information on how to connect LTC to the AirSpeed 5000 server. Depending
on your site’s needs, there are two methods to connect LTC to your server.
No matter what choice you have decided on (cable or Multi I/O Expansion Panel), the LTC
signal will always be the same.
To connect LTC to the server:
t If you only have one LTC signal, do the following:
a. Connect directly to the server using the Reference and LTC Breakout cable
(7070-30344-00).
b. (Option) If using LTC IN, connect the LTC IN connector to a valid LTC IN source.
t If you require multiple LTC Inputs, do the following:
a. Connect to the Multi I/O Expansion panel.
b. Connect up to four (e.g., one for each channel) LTC IN sources (e.g., analog audio
source, TOD system clock, or as a video source for the time-based recordings) to the
LTC IN ports on the Multi I/O Expansion Panel.
n
One of these LTC IN ports could be used for a TOD source.
c. Connect up to four (e.g., one for each channel) LTC OUT sources to the LTC IN ports
on the Multi I/O Expansion Panel.