Setup guide

Cabling Up the AirSpeed 5000 Server
47
The following illustration shows the location of the Auxiliary Monitor Output connectors on the
rear of the AirSpeed 5000 chassis.
To connect Auxiliary (1.0/2.3) to BNC cables:
1. Connect one end of the Auxiliary (1.0/2.3) to BNC adapter to one of the Monitor Outputs
(labelled Monitor OUT 1-4 in the diagram) on the rear of the AirSpeed 5000 server.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Monitor
OUT 3 and Monitor OUT 4 connections are not available.
2. Connect the other end of the Auxiliary (1.0/2.3) to BNC adapter cables to an auxiliary
output device, such as an output monitor for the channel that you want to receive the output
signal from the AirSpeed 5000 server.
Monitor OUT 1
Monitor OUT 2
Monitor OUT 4
Monitor OUT 3