Setup guide

Cabling Up the AirSpeed 5000 Server
46
The following illustration shows the location of the SDI OUT video connectors on the rear of the
AirSpeed 5000 chassis.
To connect SDI video output cables on the chassis:
1. Ensure that you have the proper SDI video (75 ohm-rated) interface coaxial cables available.
2. Connect the SDI output signal to an outgoing SDI output (one of the four labelled Video
OUT1-4 in the diagram) for AirSpeed 5000 server.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Video
OUT 3 and Video OUT 4 connections are not available.
3. Connect the other end of all SDI output cables to your devices that are receiving the output
signal from the AirSpeed 5000 server.
Connecting Auxiliary Monitor Outputs
The four Auxiliary Monitor Output connections are marked on the rear of the AirSpeed 5000
server. They are used to connect an auxiliary device, such as a monitor.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Monitor
OUT 3 and Monitor OUT 4 connections are not available.
Four (4) 1.0/2.3 to BNC adapter cables (7070-30387-00) are provided for connecting Monitor
outputs.
n
You must use these cables.
Video OUT 1 Video OUT 2
Video OUT 4
Video OUT 3
Multi I/O
Expansion Card