Setup guide

Cabling Up the AirSpeed 5000 Server
45
Connecting SDI Video Inputs
The four SDI Video Input connections are marked on the rear of the AirSpeed 5000 server.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Video IN
3 and Video IN 4 connections are not available.
The following illustration shows the location of the SDI IN video connectors on the rear of the
AirSpeed 5000 server.
To connect SDI video input cables:
1. Ensure that you have the proper SDI video (75 ohm-rated) interface coaxial cables available.
2. Connect the SDI input signal to an incoming SDI input (one of the four labelled Video IN
1-4 in the diagram) on the AirSpeed 5000 server.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Video IN
3 and Video IN 4 connections are not available.
3. Connect the other end of all SDI input cables to your devices that are sending the input
signal to the AirSpeed 5000 server.
Connecting SDI Video Outputs
Each Video I/O card contains two Video Inputs, two Video Outputs, and two Auxiliary outputs.
The four SDI Video Output connections (two on each Video I/O Card) are marked on the rear of
the AirSpeed 5000 server.
n
AirSpeed 5000 2-channel model servers only contain one Video I/O card. Therefore, the Video
OUT 3 and Video OUT 4 connections are not available.
Video IN 1
Video IN 2
Video IN 4
Video IN 3
Multi I/O
Expansion Card