Setup guide

Installing Avid AirSpeed 5000 Hardware in a Rack
32
Attaching Inner Slide Rails to the Avid AirSpeed 5000
Attach the inner slide rails that were separated from the outer slide rails to the Avid AirSpeed
5000.
To attach the inner slide rails:
1. Position the inner slide rail against the side of the server so that the screw holes are toward
the rear of the server, and front of the slide rail fits over the tab at the front of the server.
2. Secure the inner slide rail to the server with two of the small screws.
n
You might find more screws in the rail kit than is needed, and described in this procedure.
Attaching the Inner Slide Rails
3. Repeat this procedure to attach the other inner slide rail on the other side of the server.
Attaching the Outer Rails to a Square-Hole Rack
After separating the slide rails as previously described (see “Separating the Slide Rails” on
page 31), perform the following procedure. If your mounting rails have round holes, see
“Attaching the Outer Rails to a Round-Hole Rack” on page 34.
To attach the outer slide rails to the rack with square holes:
1. Align the outer slide rail bracket assembly with the front rack-mounding holes.
n
You should have someone helping you hold the slide rails level while you are positioning them in
the rack.