Setup guide

Installing Codecs On Your Video I/O Board (2-Channel Models Only)
25
3. Using the supplied set screws and a #2 Phillips head screwdriver, do the following:
a. Align the holes in the codec to the standoffs on the Video I/O board
b. Firmly, attach the first codec to the connector on the Video I/O board.
n
Codecs can only be placed one way.
c. Repeat Step 3 for the second codec.
When both codecs are screwed down to the Video I/O board, it will look like this:
4. The next step is to replace the Video I/O board (with the codec modules installed) back into
the server. For more information, see “Replacing the Video I/O Board into the Chassis” on
page 25.
Replacing the Video I/O Board into the Chassis
This topic contains information on how to replace the Video I/O boards in the server chassis.
To replace the VIO board into the chassis:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 19 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.
2. Gently replace Video I/O board (VIO 1) into the top riser card slot.
3. Replace the Board Locking Bracket back down into it’s slot, and tighten the thumbscrews.
Codecs secured to Video I/O Board