Setup guide
Installing Codecs On Your Video I/O Board (2-Channel Models Only)
24
Attaching the Codec Modules to the Video I/O Board
This topic contains information on how to attach two (2) codec modules to the Video I/O board.
n
This procedure applies to both the MPEG-2 HD and the AVC-Intra codec module kits.
To attach the Codec modules to the Video I/O board:
1. Open the MPEG-2 HD, or AVC-Intra Codec Module kit that contains the codec modules
that you are upgrading to, and place them on your workspace.
2. Take Video I/O board #1 (VIO 1), and place it component side up (with the standoffs
showing).
Standos for codec
Standos for codec