Setup guide

Installing Codecs On Your Video I/O Board (2-Channel Models Only)
21
To remove the VIO board from the chassis:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 19 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.
2. Power down the server and unplug all peripheral devices and the AC power cables.
3. Remove the server main cover. For instructions, see “Removing and Replacing the Server
Main Cover (2-Channel Models)” on page 20.
4. Disconnect any cables attached to any add-in cards.
5. Loosen the thumbscrews on the back cover, and slide the cover back to remove it from the
chassis.
The following diagram shows the location of the two (2) thumbscrews on the rear of the
server.
6. Loosen the thumbscrew on the card guide, and slide it over to remove it from the chassis.
The following diagram shows the location of the Card guide thumbscrew.
Two (2) Thumbscrews
Card Guide thumbscrew