Setup guide

Preventative Maintenance
87
29. The next step is to set up your system. This is described in the topic “Configuring the
AirSpeed 5000 for Your Network” on page 68.
When you are done with that, you can re-install the latest version of the AirSpeed 5000
server software for your site, as described in “Installing AirSpeed 5000 Server Software” on
page 87.
Installing AirSpeed 5000 Server Software
For new systems, the AirSpeed 5000 server software is pre-installed on your server. However, in
the case where you have re-imaged your AirSpeed 5000 server, or are updating your AirSpeed
5000 server software version, you need to install the latest Avid Service Framework, and
AirSpeed 5000 application software using the AvidAirSpeed5000Setup.exe.
This topic contains information on how to install the AirSpeed 5000 server software on the
AirSpeed 5000 server.
c
If this is a new AirSpeed 5000 system, it has been pre-loaded with the AirSpeed 5000
software. You need to install the AirSpeed 5000 server application software only if you are
upgrading your software version, or have re-imaged your system.
n
When installing or upgrading your AirSpeed 5000 software, you must run the installer when
logged into the system from the same network or subnet in which the system is configured. Some
remote access or desktop solutions may access the system with different permissions, potentially
causing installation and configuration of IIS and SQL components to fail. This is likely to be an
issue when attempting to update a system via an Internet-based remote solution that does not use
a direct VPN connection.
n
Log on as amsuser and is-admin as the password.
n
Some USB flash devices might not appear in a Safely Remove Hardware dialog box even though
they are plugged in. In addition, it might take several seconds for a USB device to be available to
the system.